EarthQuake PH10000W/D1 소유자 매뉴얼 - 페이지 8

{카테고리_이름} EarthQuake PH10000W/D1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake PH10000W/D1 10 페이지. Powerhouse series amplifiers
EarthQuake PH10000W/D1에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (10 페이지)

페이지 인쇄

PH5000W/ 1

SIGNAL SENSOR: This feature allows you to

eliminate the use of a remote wire to turn on your

ampliﬁer.

In AUTO mode the amp will

automatically detect an incoming signal when the

stereo is turned on. If the ampliﬁer does not

detect a signal within 20min. it will automatically

shutdown. When in REMOTE mode the ampliﬁer

relies on the remote wire to detect a signal.

FUSE RATING SHOULD BE

NO LESS THAN 120 AMPERES

DO NOT SOLDER THE TIP OF THE POWER

CABLE (+&-). IT REDUCES THE CONTACT

SURFACE BETWEEN THE CABLE AND THE

INSIDE

THE

TERMINAL.

WHEN

TIGHTENING THE SCREW, A RAW CABLE (NO

SOLDER) EXPANDS INSIDE THE TERMINAL

CREATING LARGER CONTACT SURFACE;

THUS ELIMINATING HOT JUNCTIONS.

Speciﬁcations Are Subject To Change Without Notice

Auto On Remote On

The gain knob is not a volume control.

It is designed to match the input level

of the amp to the output level of the

source unit. Over driving -clipping- the

input stage of the amp will cause

damage to the ampliﬁer (Please refer

to table for settings).

REM

GND

BAT

To battery (+)

To car chassis / ground

To remote turn on / trigger

• Test the alternator output. Factory alternator will produce 60 to 80 amperes at best. Wear and heat

will reduce the output by 40%.

• Alternator ground (-) must be reinforced, use 4-gauge cable instead of the factory 8-gauge.

• Alternator positive (+) to battery (+) must be reinforced. Use 4-gauge cables.

• Check your battery condition. Batteries degrade after a while.

• Battery (+) to ampliﬁer (+) , must be a 4-gauge cable.

• Ground ampliﬁer to chassis using 4-gauge cable, keep the cable short (maximum 2-feet).

• Use 1 farad capacitor to compensate for surges in demand.

• We recommend the use of one (1) auxiliary battery.

One Subwoofer

Two Subwoofers

For best performance, set the

crossover knob to 200Hz (max).

Set the gain to minimum, and

slowly raise the gain. In general,

an ideal gain setting ranges

between the 9 to 10 O' Clock

position