EarthQuake PH20000W/D1 소유자 매뉴얼 - 페이지 5

{카테고리_이름} EarthQuake PH20000W/D1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake PH20000W/D1 10 페이지. Powerhouse series amplifiers
EarthQuake PH20000W/D1에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 소유자 매뉴얼 (11 페이지), 소유자 매뉴얼 (10 페이지)

페이지 인쇄

PH1000W/2

+18dB boost @ 45Hz

+12dB boost @

designed to shape/

12kHz essential

boost the response

boost for high-pass

curve in a low-pass

amplifier applications

mode application.

SPEAKER

CH1

CH2

MONO

S p e a k e r O u t p u t s

Minimum 4 Ohm Mono

Specifications Are Subject To Change Without Notice

3-way switch

RCA level inputs, with

runs the amp

a range of 0.2V to 5V.

in low-pass,

RMS.

full-range or

high-pass

3-way switch feeds RCA

mode.

outputs a low-pass full-

range or high pass signal.

Crossed RCA level

outputs, can be used

to feed other amplifiers

in the system.

The gain knob is not a volume control.

It is designed to match the input level

of the amp to the output level of the

source unit. Over driving -clipping- the

input stage of the amp will cause

damage to the amplifier (Please refer

to table for settings).

BAT

REM GND

FUSE

POWER

Born In The USA

To car chassis / ground

30A Fuse

To remote turn on / trigger

To battery (+)

The PH1000W/2 is designed to

operate in stereo or mono mode. When

used in stereo applications, a minimum

load of 2 ohms per channel is required.

Set Xover knob to

Minimum (20Hz), &

set Xover switch to

Full Range

FC6.2

Tweeter

FC6.2 Midrange

The PH1000W/2 is designed to

operate in mono mode. When

bridging the two channels, a

minimum load of 4-ohms is

required.