EarthQuake 9000E 운영자 매뉴얼 - 페이지 7
{카테고리_이름} EarthQuake 9000E에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthQuake 9000E 12 페이지. Power earth auger
EarthQuake 9000E에 대해서도 마찬가지입니다: 운영자 매뉴얼 (12 페이지)
SERVICE
SERVICE , TROUBLESHOO
SERVICE
, TROUBLESHOO
, TROUBLESHOO TING AND REP
, TROUBLESHOO
SERVICE
SERVICE
, TROUBLESHOO
TROUBLESHOO
TROUBLESHOOTING
TROUBLESHOO
TING
TING
TING
TROUBLESHOO
TROUBLESHOO
TING
Problem
Engine will not start
Engine runs rough, floods during operation
Engine is hard to start
Engine misses or lacks power
Auger turns at idle
Auger turns, but has no power
Auger jumps on ice
Auger cuts slowly
Engine runs, then quits
TING AND REP AIR
TING AND REP
TING AND REP
AIR
AIR
AIR
TING AND REP
AIR
CAUTION
Practice safety at all times. Engine must
be turned off and allowed to cool, and
spark plug wire must be disconnected
before attempting any maintenance or
repair.
Possible cause
1. Power switch off
2. Spark plug wire disconnected
1. Dirty air cleaner
2. Choke partially engaged
3. Carburetor out of adjustment
1. Stale fuel
2. Spark plug wire loose
3. Dirty carburetor
1. Clogged fuel tank
2. Clogged air cleaner
3. Improper carburetor adjustment
4. Spark plug dirty, improper gap, or wrong
type
1. Idle speed too high
2. Broken clutch spring
1. Choke on
2. Carburetor out of adjustment
3. Broken transmission
4. Worn clutch shoes
5. Worn engine lower seal
1. Blades damaged or sharpened incorrectly
1. Dull blades
2. Damaged point
1. Gas cap not venting
2. Screen in carburetor plugged
Page 7
Remedy/Action
1. Flip switch to on position
2. Connect spark plug wire to spark plug
1. Clean or replace air cleaner
2. Turn off choke
3. Call factory
1. Drain old fuel and replace with fresh. Use
gas stabilizer at end of season
2. Make sure spark wire is securely attached
to spark plug
3. Clean carburetor, use gas stabilizer, new
gas can
1. Remove and clean
2. Clean or replace
3. Call factory
4. Replace spark plug and adjust gap
1. Adjust idle speed lower
2. Replace both springs
1. Turn off choke after engine is running
2. Call factory
3. Call factory
4. Replace clutch shoes and springs
5. Call factory
1. Buy new blades, or have blades sharpened
at factory
1. Buy new blades, or have blades sharpened
at factory
2. File point
1. Check self venting gas cap
2. Clean screen, use gas stabilizer, clean gas
can
ARDISAM