360 BANDIT GREAT PLAINS 설치 지침 - 페이지 2
{카테고리_이름} 360 BANDIT GREAT PLAINS에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 BANDIT GREAT PLAINS 4 페이지.
페이지 인쇄INSTALLATION INSTRUCTIONS
GREAT PLAINS
BEFORE YOU BEGIN...
HELPFUL TOOLS
Hammer/Mallet
Wrench Sizes: 15/16" and 7/16"
Socket Sizes: 16mm, 15/16", 18mm and 7/16"
Impact
Torque Wrench
STEP 1
REMOVE CLOSING SYSTEM
2
Release spring 1 to remove tension from closing system.
NOTE: If the optional chains kit is not being installed do not
remove the closing wheels.
If present, remove insecticide attachment.
Using an 3/4" socket remove the two bolts that attach
the closing system casting 2 to the row unit and set the
closing system casting aside. Bolts can be discarded.
PAGE 2
STEP 2
INSTALL BANDIT UNIT
1
3
4
Using one of the long bolts 3 and one of the short bolts 4
from the provided hardware kit, attach the 360 BANDIT
unit (long leg to the rear) to the row unit where the closing
system casting was just removed. The longer bolt will be
used in the front hole and the shorter bolt will be used in
the rear hold.
Tighten with 16 mm socket. Torque bolts to 42.2 ft lbs.
Ensure not to over tighten bolts.
4