Allied Vision Alvium 매뉴얼 - 페이지 15
{카테고리_이름} Allied Vision Alvium에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Vision Alvium 18 페이지.
페이지 인쇄9.4. Reassembling Prosilica GT Extended Format housing cameras
1. Position sensor unit and lens mount, so that markers (c) align.
2. Keeping screws (a) and spacers in place, fit the sensor unit (b) as a unit into the lens mount (d)
a
3. Tighten the two M2 x 16 socket head cap screws (e) at a maximum torque of 4 lbf-in (0.45 Nm).
Figure 25: Tightening the two M2 x 16 socket head cap screws
4. Position front assembly and body assembly, so that markers (g) align.
5. Mount the front assembly (f) to the body assembly (h).
Figure 26: Mounting the front assembly to the body assembly
6. Insert and tighten the four M2 x 8 socket head cap screws at a maximum torque of 4.5 lbf-in (0.51 Nm).
Figure 27: Inserting and tightening the four M2 x 8 socket head cap screws of the front assembly
b
c
Figure 24: Fitting the sensor unit into the lens mount
e
f
g
Page 15 of 18
Preparing Cameras without
Sensor Cover Glass
d
e
h