EarthWay 2170-XL 조립 지침 매뉴얼 - 페이지 2

{카테고리_이름} EarthWay 2170-XL에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 2170-XL 10 페이지. Commercial broadcast spreader with side spread control

Assembly and Operation Instructions

HELPFUL HINTS

 Read the directions before assembly.

 If your spreader does not spread evenly, be sure "FRONT" on the GEARBOX points to the front of the spreader. The

impeller must turn clockwise when pushing forward. Reversing the GEARBOX during assembly will cause issues.

 Your spreader is calibrated for three miles per hour, which is a brisk walking speed. Slower or faster speeds will

change the spread pattern. Wet fertilizer will also change the spread pattern and flow rate. Do not use powdered

materials as it will damage the gearbox.

 Gears are permanently lubricated at the factory. Do not open the GEARBOX or dirt may enter.

SPREADER ASSEMBLY INSTRUCTIONS

Remove all components and hardware

Step 1:

items from the box. Place the spreader hopper

upside down and facing away from yourself.

Install FRAME using (4) #14 x 1½" Flat

Step 2:

Head Phillips screws. TIGHTEN THESE NOW

Install impeller onto pinion shaft by

Step 3:

pressing the impeller as shown onto the pinion shaft

and turning the impeller while holding the pinion

shaft to engage with the COIN fully, and press down

to secure.

Next, insert Cross Brace thru the Gearbox Brace as

shown above.

2170_M52164_RevJune2021

IF YOUR SPREADER COMES SEMI ASSEMBLED, SKIP TO STEP #7

PAGE 2