EarthWay EV-N-Spred C22HDS 조립 및 작동 지침 매뉴얼 - 페이지 4
{카테고리_이름} EarthWay EV-N-Spred C22HDS에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay EV-N-Spred C22HDS 8 페이지. Broadcast spreader
EarthWay EV-N-Spred C22HDS에 대해서도 마찬가지입니다: 조립 및 작동 지침 매뉴얼 (6 페이지), 조립 및 작동 지침 매뉴얼 (6 페이지)
페이지 인쇄
10. Install handle shaft to lower handles and pivot & bracket assembly as shown. Using
(4) 1 ¾" bolts with cupped washers and (4) locknuts (2) cupped washers. [TIP: Attach
right side first with cupped washers on both nuts and bolts, then attach left (Pivot
Bracket) side with washers only on the bolt side]
TIGHTEN BOLTS AND NUTS NOW.
11. Install flattened end of control rod in to lever on gauge
into Control Rod Tabbed hole as shown. Turn to lock in place.
NEXT: Install (1) 1/4-20 Regular Nut [not a locknut] on to
Control Rod and thread halfway as shown to the left.
and (Cupped Washer
12. Next push lever forward to setting "0". Align control rod with hole in pivot
bracket, pull lever backward to insert control rod through hole in pivot bracket.
[TIP: If the lever does not move easily, loosen
easier] Now install 1/4-20 regular nut on to Control rod.
DO NOT TIGHTEN NUTS YET.
13. Pull lever back to setting "30" as shown. Next push pivot & bracket for-
ward so that the shut off plate in the hopper is in the full open position. [NOTE:
THE SETTING OF "30" ON THE GAUGE & LEVER ASSEMBLY MUST
OPEN THE SHUT-OFF COMPLETELY FOR PROPER CALIBRATION.]
Now tighten the nuts against the pivot bracket to prevent change in calibration.
Test by opening and closing the Gauge & Lever a few times to ensure an accurate
calibration.
14. Tension on the flow control lever may be adjusted by tightening or loosening
the tension nut as shown on the right.
PAGE 4
¼-20 X 1¾"
Hex Head Bolt
and (Cupped Washer
for C22HD)
¼-20
Lock Nut
for C22HD)
slightly to make this step
Setting #30
Insert Control Rod
Pivot Bracket
CALIBRATION POINT
Attach ¼-20 REGULAR
(NOT LOCKNUTS) Hex Nuts
at these points.
Notice the position
of the double bend point.
15. Insert Agitator to pinion shaft on inside of hopper.
NOTE: Position of flat side of agitator. This pin should
be installed as shown below.
Gauge & Lever
Lever Tensioning Nut
into
Control Rod
Tabbed Hole
Control Rod