EarthWay EV-N-SPRED C24HD 조립 및 작동 지침 매뉴얼 - 페이지 2
{카테고리_이름} EarthWay EV-N-SPRED C24HD에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay EV-N-SPRED C24HD 10 페이지. Broadcast spreader
EarthWay EV-N-SPRED C24HD에 대해서도 마찬가지입니다: 조립 및 작동 지침 매뉴얼 (6 페이지), 조립 및 작동 지침 매뉴얼 (9 페이지)
페이지 인쇄
GEARBOX ASSEMBLY
Impeller
Cross Brace
3. Install impeller onto pinion shaft. Insert 1/8" x 1¼" cotter pin
through impeller then through pinion shaft. Use hole nearest
gear box. Spread cotter pin to prevent from falling out. Next,
install the Cross Brace through the Gearbox Brace Support as
shown above.
4. Install Gearbox by inserting the pinion shaft into hole
in center of hoppers bottom. The word "FRONT" on the
gearbox must point to FRONT of the hopper.
5. Install the Lower Handles: insert 2¼" bolt with cupped
washer (C24HD) through second hole (approximately
in the middle of the Lower Handle) in lower handle and
through first hole in frame and secure with locknut.
A. Now insert 1½" bolt through first hole in lower handle,
then through frame brace, and finally into the threaded
connector in the Cross Brace. [NOTE: Numbers on frame
braces must be facing toward gearbox as shown.]
Install the Foot into the Frame and align the bolt holes in
the Foot and the Frame (a Phillips screwdriver or large
nail is helpful to align the parts)
B. Next insert 1½" bolt through other end of frame brace
and through second hole in frame through the foot and
install cupped washer (C24HD) and locknut.
DO NOT TIGHTEN YET.
PAGE 2
Pinion
Shaft
1/8 x 1-1/4"
Cotter Pin (#36105)
Gearbox Brace
¼-20 x 2¼"
Hex Head Bolt
and cupped washer
TIP: P
Frame brace
¼-20 x 1½"
Hex Head Bolt
and cupped washer
Step 5A
Step 5B
Step 5
n
Otice cupped wAsher lOcAtiOns
osITIon cuPPed washers beTween nuT or bolT head and chassIs
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS
STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
Gearbox
Assembly
Cross Brace
Foot
Impeller
Shut-Off
¼-20 Lock nut
and cupped washer
-
c24hd
On
¼-20 x 1½"
Hex Head Bolt
Frame
Lower Handle
Only