EarthWay 14100 조립 지침 - 페이지 3

{카테고리_이름} EarthWay 14100에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 14100 5 페이지.

Assembly and Operation Instructions

Moun ng Steps

Installation: Wall

Use this method for stone or brick walls...

WARNING: Ensure there are no live electrical wires or

plumbing in the wall at the location you are drilling.

CAUTION: When using power tools such as an

electric drill, please wear eye protection.

1. Using your electric drill, 10mm (3/8") masonry drill bit and bubble level, drill the hole-

pattern shown, making each hole about 2" deep.

Take care to ensure that the pattern is level.

2. Remove the nut, lock washer, and flat washer from the expansion bolt (B.1).

3. Insert the expansion bolts (with sleeves) into the holes.

4. Mount the Wall Bracket (D) on to the bolts, then assembled the nut, lock washer,

And flat washer. Tighten the nut until the expansion bolt is secure.

5. Hang Hose Reel (C) on wall bracket (D).

6. Connect leader hose to water source.

Steps

1. Tape the drilling template on the wall at a convenient height, making sure the

holes are between studs.

2. Check the hole centers with the level to ensure they are plumb.

3. Drill (4) four holes with a 10mm (3/8in) masonry drill bit on the template centers.

4. Tap plas c anchors (B.3) into holes with a hammer or mallet.

5. Fasten the moun ng bracket with four lag bolts and washer to the wall or

mber post and ensure drive moun ng screws into the plas c anchors) in

wall.

6. Hang the hose reel on the wall bracket and secure it by inser ng the

mount tube.

7. Connect with inlet hose end with the water source.

EarthWay 14100 – 100' Hose Reel

lock washer

nut

B.1

insert in this

direction

sleeve

expansion bolt

flat washer

B.1

76mm (3")

208mm (8 ")

80cm (32")

(recommended)

the

PAGE 3