EarthWise CST00012 운영자 매뉴얼 - 페이지 6
{카테고리_이름} EarthWise CST00012에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWise CST00012 8 페이지. Cordless 18 volt string trimmer
EarthWise CST00012에 대해서도 마찬가지입니다: 운영자 매뉴얼 (9 페이지)
페이지 인쇄
CAUTION: Do not at any time let brake fluids, gasoline,
petroleum based products, penetrating oils, etc., come in
contact with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
Make sure the battery is detached from the unit, then use
only mild soap and a damp cloth to clean the tool. Never let
any liquid get inside the tool; never immerse any part of the
tool into a liquid.
Fertilizers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals Do not store the
tool on or adjacent to fertilizers or chemicals.
Problem
- Unit does not run
- Battery not making contact
- Lock off not fully operated
- Battery not installed properly
- Battery not charged
- Line won't feed
- Line tangled in spool
- Line fails to cut off
- Line cutter in guard is damaged or missing
- Battery will not charge
- Battery not inserted into charger
- Charger not plugged in
- Surrounding air temperature too hot or too cold
Call us first with questions about operating or maintaining your string trimmer
at 1.800.313.5111 between 7:30 a.m. – 4:30 p.m. Eastern Standard Time,
MAINTENANCE
IMPORTANT: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment should
be performed by an authorized service center or other
qualified service organization, always using identical
replacement parts.
If you drop the trimmer, carefully inspect it for damage. If the
blade is bent, housing cracked, or handles broken or if you
see any other condition that may affect the trimmer's
operation, contact your local Authorized Service Center for
repairs before putting it back into use.
TROUBLESHOOTING
Possible Cause
CALL US FIRST !!
or send emails to [email protected].
Possible Solution
- Check battery is fully inserted
- Check that lock off is fully forward prior to
moving trigger
- Check battery installation
- Check battery charging requirements
- Unwrap 24" of line and rewind
- Replace guard
- Insert battery into charger until red LED appears
- Plug charger into a working outlet
- Check current at receptacle by plugging in a
lamp or other appliance
- Check to see if receptacle is connected to a
light switch which turns power off when you
turn out the lights
- Move charger and tool to a surrounding air
temperature of above 40 degree F
(4,5 degree C) or below 105 degree F
( +40,5 degree C)