EarthWise SN71018 운영자 매뉴얼 - 페이지 15
{카테고리_이름} EarthWise SN71018에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWise SN71018 17 페이지. 18” snow thrower
페이지 인쇄
Run the snow thrower for a few minutes to melt away any
snow on the snow thrower.
Disconnect the extension cord from the snow thrower.
Examine the extension cord thoroughly for signs of wear
or damage. Replace it if it is worn or damaged.
Problem
Motor does not start
Poor results
Abnormal vibrations
Motor shuts off during
operation
SERVICE
Now that you have purchased your snow thrower, should you need repair parts or service, simply contact us at
1-800-313-5111. Be sure to provide all pertinent facts when you call.
REPAIR PARTS
Please record your serial number in the space provided below.
•
NAME OF ITEM
•
MODEL NUMBER
•
SERIAL NUMBER
Call us first with questions about operating or maintaining this product at 1.800.313.5111
between 7:30 a.m. – 4:30 p.m. Eastern Standard Time, or send emails to [email protected].
TROUBLESHOOTING
Possible causes
Unit not plugged in.
No electricity.
Defective cable.
Drive belt worn or damaged.
Auger worn or damaged.
Discharge chute blocked.
Drive belt worn or damaged.
Auger worn or damaged.
Scraper blade worn or damaged.
Current too high
Snow Thrower
SN71018
The Great States Corporation
American Lawn Mower Company
www.americanlawnmower.com
STORAGE
Examine the snow thrower thoroughly for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary. To repair or replace parts, contact
our customer service help line at 1-800-313-5111.
Store the snow thrower, along with.the disconnected
extension cord, in a clean, dry place out of reach of
children. Cover loosely with a tarp for added protection.
Remedy
Plug in the unit.
Check power supply.
Check cable. Repair or replace if required.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Switch off the snow thrower and clean the discharge
chute.
Replace the drive belt.
Replace the auger. Ensure the screws and nuts are
properly tightened.
Replace the scraper blade. Ensure the screws are
properly tightened.
Push reset button. Restart the snow thrower.
CALL US FIRST !!
830 Webster Street
Shelbyville, IN 46176
15