Christie CP2230 기술 게시판 - 페이지 2

{카테고리_이름} Christie CP2230에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Christie CP2230 6 페이지. Christie rack mount pedestal
Christie CP2230에 대해서도 마찬가지입니다: 지침서 (6 페이지), 지침서 (9 페이지), 기술 게시판 (8 페이지), 매뉴얼 (2 페이지), 설치 및 설정 매뉴얼 (19 페이지)

페이지 인쇄

Replace the ICP battery

The ICP is installed in the card cage located on the operator (left) side of the projector facing the

lens. This procedure describes the replacement of an ICP battery in a Christie CP2215 projector. For

removal instructions that are specific to your projector model, see the projector Service Manual.

To prevent damage to the projector or personal injury, complete the procedures in the order they

are written.

Backup projector settings and information

This procedure is optional, but is recommended to make sure you can recover your data if an error

occurs.

1. Insert a USB flash drive into the USB port on the side of the projector touch panel controller

(TPC).

2. Log on to the projector with service permissions.

3. On the TPC, tap Menu > Service Setup > File Management.

4. Tap Backup.

5. When the backup is complete, remove the USB flash drive and store it in a secure location.

Prepare the projector for service

1. If the lamp is on, tap the lamp off (

2. Allow the lamp to cool for a minimum of 15 minutes.

3. Tap and hold the power off (

4. Disconnect the projector from AC power.

Remove the ICP

1. Loosen the seven screws that secure the top lid to the projector

2. Lift the lid up from the rear of the projector and set it aside.

Replacing the ICP Battery Technical Bulletin

020-200313-01 Rev. 1 (02-2015)

) icon on the projector TPC to turn it off.

) icon to turn the projector off.