Miele NOVOTRONIC W 1918 사용 설명서 - 페이지 42

{카테고리_이름} Miele NOVOTRONIC W 1918에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele NOVOTRONIC W 1918 48 페이지. Miele washer user manual
Miele NOVOTRONIC W 1918에 대해서도 마찬가지입니다: 사용 설명서 (48 페이지)

페이지 인쇄

Plumbing

Connect the cold water supply hose

(marked blue) to the cold water tap

and the warm water supply hose

(marked red) to the warm water tap.

Turn on taps and check for leakage.

The water pressure must be within the

0.1-1 MPa (14 – 140 psi) range. If the

water pressure is greater than 1 Mpa

(140 psi), a reducer valve must be

fitted. At pressures below 0.1 Mpa

(14 psi), the standard inlet valve of the

machine must be exchanged for a low

pressure version by an authorized

Miele Service Technician.

The water supply hoses are equipped

with a strainer filter; please do not

remove this filter.

Special note

If the machine is not to be connected

to a hot water supply, it is essential

that the hot water inlet hose is also

connected to the cold water supply,

using a Y connector. Otherwise cor-

rect functioning of the machine

could be impeded.

It is not allowed to connect the ma-

chine to a hot water supply only, for

functional and safety reasons.

Connection to the drainage system

The 1.5 m hooked drain hose may be

connected as follows:

1. Directly into a sink: hook the hose se-

curely over the edge and secure,

e.g. by tying the hose to the water

tap.

2. Connection to a drain pipe: fit drain

hose into a 38 mm ( 1

secure firmly. (An antisiphoning de-

vice is not required.)

3. Drainage into floor gully: if required,

the drain hose may be extended to

5 m (15 ft.) maximum.

The machine drains via a pump with a

maximum delivery head of 1.2 m (4 ft.).

The hose must not be kinked as this

restricts drainage.

") pipe and

1/ 2