Miele PW 6167 사용 설명서 - 페이지 27

{카테고리_이름} Miele PW 6167에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6167 40 페이지.
Miele PW 6167에 대해서도 마찬가지입니다: 매뉴얼 (48 페이지)

페이지 인쇄
Miele PW 6167 사용 설명서

Error messages

,
Repairs to electrical, gas or steam operated
machines may only be carried out by a suitably
qualified person in accordance with national and
local safety regulations. In the U.K. repairs to gas
heated machines must only be carried out by a
Gas Safe registered technician.
A message will appear in the display if there is a
problem either before starting a programme or once it
has started:
The display remains dark.
There is no power to the machine.
^ Check the mains switch and the on-site fuses.
Power cut
y
Programme stop
Press the start button.
^ Once power has been restored press the START
button.
This error message can also indicate that the winding
on the motor has overheated.
^ Allow the motor to cool down.
Water inlet fault
M
Call the Service Department
if restart does not work.
i
^ Check the tap and then press the START button.
Door lock fault
a
Call the Service Department
if restart does not work.
i
^ Push firmly on the door handle until you hear the
lock engaging. Confirm by pressing START.
Heating system fault
§
Programme stopped. Press start.
Programme will continue without heat.
i
^ To continue the programme with heating press the
START button. If a disinfection programme was
running the programme will be cancelled if this
message appears.
Call the Service Department.
Drive motor fault
m
Programme stopped. Press the start button.
Motor overheating.
i
^ Allow the motor to cool down.
Imbalance fault
§
Call the Service Department
if restart does not work.
f
i
The imbalance is too great and the imbalance switch
has been activated.
^ Switch the machine off and on again. Then press
the START button.
Gas system fault
§
Open the gas tap.
Press the start button.
i
f
If this message appears before a programme has
been started:
^ Open the gas tap and then press the START
button.
If this message appears during a programme the
pressure in the gas supply has dropped because of
other gas heated appliances operating at the same
time.
f
^ Press the START button.
Problem solving guide
f
f
A
f
27