Miele PW 6241 작동 및 설치 지침 - 페이지 24

{카테고리_이름} Miele PW 6241에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6241 44 페이지.
Miele PW 6241에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 사용 설명서 (46 페이지), 프로그래밍 지침 매뉴얼 (48 페이지)

페이지 인쇄

1. Fault Messages

Optional modules

Priming the dispensing pumps

Use the calibration to get liquid detergent to the

pumphead. Once calibration is complete run an

empty program to get detergent to the machine

before actually washing a load of laundry in the

machine.

Dispensing calibration

The dispensing calibration is used to calculate the

flow rate of each dispensing pump.

For direct access to the dispensing calibration when

the machine is turned off:

^ Press and hold the 2

^ Turn the machine on at the mains and release the

control key.

Dispensing calibration ~ Main menu

Dispensing pump 1

Dispensing pump 2

Selections: Dispensing pump 1 to 13

After selecting a dispensing pump the display shows:

Dispensing calibration ~ Dispensing pump 1

V: 100ml

t: 0s

The dispensing amount can be adjusted in 1 ml

increments from 0 to 999 ml.

^ Press the 0/1 control key, the dispensing hose fills.

Press the 0/1 button again to stop.

^ Point the hose of the dispensing pump to be deter-

mined, in a measuring cup. Hold the cup high

enough so the liquid has to be pumped rather than

flowing out.

Avoid skin and eye contact, wear protective

clothing.

^ Press A to get back to the main menu.

Dispensing calibration ~ Main menu

Dispensing pump 1

Dispensing pump 2

^ Select the dispensing pump.

Dispensing calibration ~ Dispensing pump 1

V: 100ml

t: 0s

control key from the left.

0/1

^ The dispensing can be manually stopped by pres-

sing the 0/1 button or it will stop automatically after

60 seconds.

^ Measure the pumped amount in the measuring

cup.

Dispensing calibration ~ Dispensing pump 1

V: 100ml

t: 30s

^ Enter the measured amount in the "V:" field. The

flow rate P: in milliliter per minute is calculated by

the control.

^ Press S "Save" to allocate the measured values to

the dispensing pump.

^ Reconnect the hose.

Maintenance of the dispensing system

Rinse the dispensing system with hot water every 2

weeks, or before shutting down the dispenser pumps

for any length of time, to prevent the system from

clogging.

^ Rinse out the suction pipes with water.

^ Place the suction pipes in a container with warm

water, 104 - 122°F (40 - 50°C).

^ Select each pump by using the dispensing cali-

bration.

^ Turn on each pump until the dispensing system is

rinsed.

^ Check the connection points, hoses and washers

for leaks.

P: 200.0 ml/min

0/1