Miele PW 6241 프로그래밍 지침 매뉴얼 - 페이지 26

{카테고리_이름} Miele PW 6241에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6241 48 페이지.
Miele PW 6241에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 사용 설명서 (46 페이지)

페이지 인쇄
Miele PW 6241 프로그래밍 지침 매뉴얼
Programming
22. Water level stop 2
Settings as for Water level stop 1
23. Wash time 2
Settings as for Wash time 1
24. Cool down
The rate at which the water is cooled down
before being drained is defined here.
Selection choice:
– No
The water is not cooled down.
– Automatic
Water is taken in in stages via the valves
specified in the programme step "Water inlet
2", with a cooling down rate of 3°C/min until
the max. level is reached in the machine.
Water is then drained to the wash level and
more water then brought in in stages until
the water temperature has reached 45°C.
The programmed required level is reduced
by 30% when it matches the maximum level
in the machine.
– User defined
Cool down temperature of 20 to 95°C
Cool down rate of 1 to 20°C/min.
25. Wash time 3
Settings as for Wash time 1
26. Programme stop 2
Settings as for Programme stop 1
27. Programme stop signal 2
Settings as for Programme stop signal 1
26
28. Drain path 1
This option is used to specify how the water
should be drained out of the machine, and
where to.
Selection choice:
– No
Water is not drained away.
The spin programme step cannot then be
set to spin speed faster than 70 rpm.
– Drain
This controls the drain valve.
– Reservoir
Water is drained into the water recovery
system.
– Empty reservoir
The WRG water recycling system reservoir is
emptied.
– Cleaning
The water in the circuit is emptied.
29. Drain level
A water level can be specified. A residual
amount of water may remain in the suds
container until the run up to spin
commences. This enables certain types of
laundry to be evenly distributed in the drum
during spinning and helps to keep any
imbalance to a minimum. The drum does not
rotate.
Selection choice:
– Water level
0 mm up to Level 1 or 2
30. Wash time 4
Settings as for Wash time 1
31. Drain path 2
Settings as for Drain path 1
M.-Nr. 06 533 430