Miele PW 6321 사용 설명서 - 페이지 31

{카테고리_이름} Miele PW 6321에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PW 6321 46 페이지.
Miele PW 6321에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 프로그래밍 지침 매뉴얼 (48 페이지)

페이지 인쇄

Service interval

If after switching the machine on the

following message appears in the display

the machine will need to be serviced by the

Miele Service Department.

Service interval 1

Call the Service Department

The display will go out after 5 minutes.

Error messages

Repairs to electrical, gas or steam

operated machines may only be carried

out by a suitably qualified person in

accordance with national and local safety

regulations. In the U.K. repairs to gas

heated machines must only be carried out

by a Gas Safe registered technician.

A message will appear in the display if there

is a problem either before starting a

programme or once it has started:

The display remains dark.

There is no power to the machine.

^ Check the mains switch and the on-site

fuses.

Power cut

Programme stop

Press the start button.

^ Once power has been restored press the

START button.

This error message can also indicate that

the winding on the motor has overheated.

^ Allow the motor to cool down.

M.-Nr. 06 572 495

Water inlet fault

Call the Service Department

if restart does not work.

^ Check the stopcock and then press the

START button.

Door lock fault

Call the Service Department

if restart does not work.

^ Push firmly on the door handle until you

hear the lock engaging. Confirm by

pressing START.

Heating system fault

Programme stopped. Press start.

Programme will continue without heat.

^ To continue the programme with heating

press the START button. If a disinfection

programme was running the programme

will be cancelled if this message appears.

Call the Service Department.

Drive motor fault

Programme stopped. Press the start button.

Motor overheating.

^ Allow the motor to cool down.

Imbalance fault

Call the Service Department

if restart does not work.

The imbalance is too great and the

imbalance switch has been activated.

^ Switch the machine off and on again. Then

press the START button.

Problem solving guide