360 Vision Sirius 설치 및 구성 매뉴얼 - 페이지 6

{카테고리_이름} 360 Vision Sirius에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 Vision Sirius 6 페이지.

Sirius Installation Manual v2.1

6 Important - Care of Painted Surfaces

The powder coating applied to the Sirius LED Array external housing is recognised as being in the forefront

for quality and finish. However, in order to preserve the aesthetic finish it is recommended that the coating is

regularly cleaned.

Regular cleaning on a maximum three month interval, using warm and mild detergent must be undertaken.

Abrasive cleaners including strong solvent must NOT be used at any time.

In areas where the coating may come in contact with concentrated atmospheric pollutants [marine, chemical

and especially bird droppings] it would be prudent to clean more frequently e.g. monthly.

Full documentation of the cleaning schedule MUST be maintained to ensure that a warranty claim can be

considered.

If damage occurs to the coating (e.g. the Sirius LED Array is dropped, scrapped etc), repairs MUST be carried

out immediately.

When the Sirius LED Array is installed in areas where there is a high risk of damage from birds or their

droppings, additional precautions and measures should be used to keep the birds away from the Sirius LED

Array e.g. fit anti-bird spikes.

Sirius LED Arrays should be handled with care and must not be dropped. When Sirius LED Arrays are being

stored before installation they should be kept in the transit packaging and located in a dry indoor environment

preferably between 1°C and 35°C which is dry and dust free. Humidity should such that water vapour is non-

condensing. Sirius LED Arrays can be allowed to be outside this range for short periods of time (24 hours

maximum) for transport (e.g. in aircraft or vans) but must never be allowed to be outside the normal operating

temperature range of -40°C to +60°C even during storage. Before installation the Sirius LED Array should be

clean and dry. (If necessary it should be cleaned and dried taking care that the glass is not scratched).

This information and/or any technical information – whether received verbally or writing – is given in good faith

but without warranty and this also applies where proprietary rights of third parties are involved. The information

provided does not release you from your obligation to check its validity and to test the products suitability for

the intended purpose(s) and use(s). The application, use and installation of the products either in isolation or in

conjunction with other products used, provided and installed by you on the basis of the technical advice issued

are beyond our control and therefore remain entirely your own responsibility.

Page 6