Miele PWM 920 DV 설치 계획 - 페이지 8

{카테고리_이름} Miele PWM 920 DV에 대한 설치 계획을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PWM 920 DV 34 페이지. Commercial washing machine

en - Installation and planning notes

Drain valve

If there is no hot water supply at the installation location, the inlet

hose for hot water must also be connected to the cold water supply.

An additional Y-piece is required in this case. Cold water consump-

tion increases accordingly to account for the missing hot water in-

take.

For functional and technical reasons it is not possible to operate

the machine exclusively with a hot water connection.

Even if a hot water connection is present, the washing machine

must be connected to a cold water intake.

A motorized dump valve is used to drain the machine. An HT DN 70

angle connector can be used for draining the machine directly into

the waste water system (without a siphon) or into an on-site gully

(with odor trap).

A vented drainage system is vital for unimpeded drainage.

If several machines are connected to a single drain pipe, this

should be sufficiently large to allow all machines to drain simultane-

ously.

The appropriate Miele installation kit mat. no.: 05 238 090 is avail-

able from Miele or Miele Technical Service for venting an

HT DN 70 pipe.

If the slope for drainage is extremely steep, the piping must be

vented to prevent formation of a vacuum in the machine's drain

system.

Slow or obstructed drainage or a backup of water in the drum as a re-

sult of undersized pipework can result in faults occurring during pro-

gram sequences, which will result in error messages appearing in the

display.

 Risk of burning due to hot suds.

Outflowing suds can be as hot as 203°F (95°C).

Avoid direct contact.

Up to 12 dispenser pumps can be connected to the washing ma-

chine.