ALLLED DynColor DC300-RL-RGB-PP 사용자 설명서 - 페이지 5
{카테고리_이름} ALLLED DynColor DC300-RL-RGB-PP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLLED DynColor DC300-RL-RGB-PP 6 페이지. Dyncolor 300-rl rgb dmx controllers
페이지 인쇄Page 5 of 6
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
5）Button "SETUP" Introduction
MODE 1-8 is static color without setup function.
Serial NO.
Displayed Content
1
INTERVAL
2
RUN SPEED
3
FLASH
4
LOAD DEFAULT
5
AUTO SELECT
6
TUBE QTY
6) How to set the DMX controller under DMX512 mode?
Under DMX512 mode, the DMX controller occupies 2 channels/addresses. The first channel/address is
for mode selection; the second channel/address is for speed selection.
Please follow the below steps to set up your DMX controller:
① Set DMX controller to DMX512 MODE;
② Set DMX channel/address for the DMX controller: if the DMX channel/address is set to 13, the
controller will occupy channel/address 13 & 14; if the DMX channel/address is set to 128, the controller
will occupy channel/address 128 & 129;
③ Manage the first channel/address on the DMX console, like 13 or 128, to select the preferred pattern
to use;
④ Manage the second channel/address on the DMX console, like 14 or 129, to set the changing speed.
RB SMOOTH
GB SMOOTH
COLOR GRADUAL
RGB GRADUAL
WHITE GRADUAL
RG GRADUAL
RB GRADUAL
GB GRADUAL
R GRADUAL
G GRADUAL
B GRADUAL
ADJUST MODE
AUTO PROGRAM
DMX512 MODE
DMX512 DECODER
Instruction
0 to 100
0 to 100
0 to 100
YES or NO
YES or NO
0-4000
Red & Blue Gradual Changing
Green & Blue Gradual Changing
7 Color Fade In /Fade Down
3 Color Fade In /Fade Down
White Color Fade In /Fade Down
Red & Green Fade In /Fade Down
Red & Blue Fade In /Fade Down
Green & Blue Fade In /Fade Down
Red Fade In /Fade Down
Green Fade In /Fade Down
Blue Fade In /Fade Down
Adjust the brightness of red, green & blue
Combine selected patterns, run them
automatically & circularly.
Select preferred pattern and manage it remotely
from DMX console.
Decoder mode activated, receive data from DMX
console. Program preferred pattern, manage red,
green & blue channels individually on the
console.
Description
Interval between 2 patterns
Run speed
Flash frequency
Load default parameters
If you want this pattern appeared in AUTO
PROGRAME, select YES, otherwise NOT
Select the actual tube quantity you have
www.allled.com