Miele W4840 - DRYER STAND 피팅 지침 매뉴얼 - 페이지 3

{카테고리_이름} Miele W4840 - DRYER STAND에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele W4840 - DRYER STAND 10 페이지. Miele wts430: install guide

Miele W4840 - DRYER STAND 피팅 지침 매뉴얼
Product Group 19
3 von 10
9
am
Parts required
Quantity
Mat. no.
1
06447280
1
00253532
Installation instructions
Danger!
The washer/dryer stand is suitable for single set-up.
When setting up a washer and dryer combination, the stands have to be connected.
The stand is not suitable for installation of a washer and dryer stack.
To prevent tipping, as a matter of standard practice, the appliances have to be bolted to the stand.
For a dryer single set-up, the stand has to be bolted to the floor with the floor installation kit M. no. 00253532. At least two feet of the
stand have to be bolted to the floor, and at least one of them has to be a rear foot. For optimum stability, fasten feet positioned diagonally.
Danger of injury: Do not stand on the drawer!
Set up only washers/dryers that are not installed, for de-installation instructions, refer to the operating instructions for the appliance.
During the installation, make sure that children or animals cannot get into the work area.
Wear non-slip work gloves and safety shoes while doing installation work. Non-compliance may lead to, e. g., slipping, and result in
serious injury.
During the installation, be sure to keep your body and especially hands and feet out of the space under the appliance, or between the
appliances.
For the installation, tip the washer onto its left side, and the dryer onto its right side. It is important to have sufficient manpower to handle
the weight of the appliances. Non-compliance may result in serious bodily injury, especially to the back. For the weight of the units, refer
to the operating instructions for the units.
Fire Hazard! Do not store flammable items in the drawers.
Before starting any service or installation work, safely disconnect the appliance from its power source.
14.12.2006
Conversion and Fitting Instructions
10
Designation
Washer/Dryer Stand 430
Installation kit for floor mounting, included with dryer for dryer solo installation
This information should not be duplicated or passed on without Miele approval. All rights reserved.
Mat. no. 06694601