Miele G 1 Series 매뉴얼 - 페이지 8
{카테고리_이름} Miele G 1 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele G 1 Series 14 페이지.
Miele G 1 Series에 대해서도 마찬가지입니다: 매뉴얼 (46 페이지)
페이지 인쇄Technical Information
5. Release the Program button.
6. If the "Rinse & Hold" LED does not light up, repeat the procedure.
Acknowledgement indicator:
The "Rinse & Hold" LED flashes slowly (1 flash per second).
Options:
Function
Software version ID check
Display and delete fault
memory
Component test
Operating hours check
LED test
Table 5: Service Mode Summary, G 1472/G 2472
1.6
Advanta - G 2020
Initial requirements:
1. Close the door.
2. Switch off the appliance.
3. Turn the selector switch to the 12 o'clock position.
Accessing:
1. Press and hold the Start/Stop button.
2. Switch on the appliance.
3. Release the Start/Stop button.
4. Immediately press the Start/Stop button 3 times; on the 3rd time, hold
Programming
Do not press the options
button. The "Tab" LED is
not lit.
Press the options button
once. The "Tab" LED
flashes once quickly
intermittently. Press the
Program button. Press it
again to display fault
codes that may have been
saved. To delete the fault
memory, press the
Program button again and
hold it for 4 s.
Press the options button
2x. The "Tab" LED flashes
2x quickly intermittently.
Press the Program
button. Press it again to
activate the next
component.
Press the options button
3x. The "Tab" LED flashes
3x quickly intermittently.
Press the options button
4x. The "Tab" LED flashes
4x quickly intermittently.
Press the Program button
once.
8
G 1xxx/G 2xxx
Display
The display shows the software
version ID no. in consecutive digits
(e.g., -818).
The display shows F and a fault
code number alternately (for a list of
fault codes, see the service
manual). If the fault memory is
empty, F and 0 are displayed
alternately. See the service manual
for a list of fault codes.
The display shows which
component is being tested. For
example, if drain pump M8 is being
tested, U and 3 are shown
alternately. For the test sequence
and background information about
individual components and their
activation, see the service manual.
The display shows the number
of operating hours as follows: If the
appliance has run for 74 hours, h, 7
and 4 are displayed alternately.
The display shows 6.1. All LEDs
light up.