Miele G 1202 매뉴얼 - 페이지 45

{카테고리_이름} Miele G 1202에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele G 1202 46 페이지.
Miele G 1202에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)

페이지 인쇄

G 1xxx/G 2xxx

Function

Resetting standard

settings

Adjusting the main wash

temperature

Water quantity

normal/increased

Activating/deactivating

sensor softener, manually

setting water hardness

Program running

time reduction

(G 2830 only)

Second interim rinse

SC (with or without

cutlery tray) - available

for ID no. -1856

Machine height setting

Country setting

Model setting

(G 2872 only)

Table 28: Service Programming Mode, G 283x/G 2872

This parameter can also be modified by the customer in the Settings menu under

External Water Softeners. See the appropriate operating/installation instructions.

If the electronic needs to be replaced during servicing, then the following steps must be

taken during programming: Set the country variant, then switch off the machine. Access

the programming mode again and set the machine height.

The SER variant includes the following countries: Portugal, France, the Netherlands,

Belgium and Great Britain.

Save and quit:

Switch off the appliance.

Programming

Select Factory default.

To reset the parameters

(settings) modified by the

customer to their standard

settings, confirm with OK.

Select Temperature.

Select Main wash or Final

rinse (G 2830 only).

Select a setting and

confirm with OK.

Select Water plus. Select

a setting; confirm with OK.

Select Water hardness.

Select a setting; confirm

with OK.

Select Shorten the

program. Make the

desired selection and

confirm with OK.

Select 2nd interim rinse.

Select a setting and

confirm with OK.

Select SC. Make the

desired selection and

confirm with OK.

Select Machine height.

Select a setting and

confirm with OK.

Select Country version.

Select a setting and

confirm with OK.

Select Model version.

Select a setting and

confirm with OK.

Technical Information

Display

The display reads Reset to

standard settings?

Options: Normal and Increased.

Increased wash temperature results

in a longer running time.

Options: Normal and Increased. If

Increased is selected, water intake

increases by 16.7 fl.oz. (500mL).

Auto = Sensor softener activated.

The water hardness at the

installation site can also be

manually set. Water hardness

range: 1°d to 70°d (1.1 to 74.9 gpg).

See Section 2.14.

The display shows the options On

and Off (standard setting).

Program-dependent running time is

reduced by reducing temperatures

and/or canceling holding times.

Options: On, Off (standard setting).

Options On, Off.

Programming function not available

at this time.

Options: Normal (G 1xxx), XXL (G

2xxx).

Setting options: EUR (Europe),

AUS (Australia), USA, JPN (Japan),

I/E (Italy/Spain), SER (S. Europe).

Options: 0 = Models w/salt con-

tainer in door: G x772, G x872; 1 =

Models w/salt container in sump: G

x672.