Miele G 636 설치 지침 매뉴얼 - 페이지 27

{카테고리_이름} Miele G 636에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele G 636 40 페이지. G 600 / g 800 series dishwasher
Miele G 636에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (40 페이지), 설치 지침 매뉴얼 (40 페이지), 설치 지침 매뉴얼 (48 페이지)

페이지 인쇄

An air gap is built into the water inlet

system to prevent potable water from

mixing with waste water.

The dishwasher can heat its own water

to the temperatures required by the

wash program. This allows the option of

connecting the machine to either a hot

or cold water source.

^ For lowest energy consumption con-

nect the dishwasher to a cold water

source.

^ For fastest possible wash times, with

slightly higher energy consumption,

connect the dishwasher to a hot

water source.

Recommended temperature:

120 °F (49 °C), max 140 °F (60 °C)

Must be between 14.5 - 145 psi

(1 -10 bar).

If the water pressure is too low, the "In-

take/Drain" or "Intake" indicator may

flash (see Operating Instructions/ "Fre-

quently asked questions").

If the water pressure is too high, a pres-

sure reducer must be installed.

The water inlet hose comes equipped

with a 3/4" female hose thread connec-

tor. This can be directly connected to a

shut off valve with 3/4" MHT (male hose

thread ends).

The hose assembly should be installed

vertically so the hose exits from the bot-

tom of the valve box (not as shown).

If this is not possible, it can be installed

horizontally, provided the hose exit re-

mains beneath the main body of the

valve box (see illustration). The valve

box should also be installed so that it is

at least 10" (24 cm) above the floor (or

base of the cabinet), so that the excess

coiled hose will remain lower than the

valve box at all points.