Allmand 11-000001 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Allmand 11-000001에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmand 11-000001 17 페이지.

MAXI LITE II

SERIAL NUMBER 10-000001 & 11-000001

Test the power output at the GFCI receptacle, while the engine is running and the main

breaker and receptacle breaker is switched to the "ON" position.

Set the multimeter to the AC volt position and insert the probe tips into the hot and

neutral sides of the GFCI receptacle.(See figure A b elow )

A meter reading of 120.0 volts +10% indicates that the generator is operating properly.

Refer to page 2. For further troubleshooting procedures.

A reading less than 120 volts + 10% indicates that the generator may be malfunctioning,

or there can be an issue with the main circuit breaker, pop out receptacle circuit

breaker, GFCI receptacle by itself, or the wiring between any of these. Refer to page 2

for additional troubleshooting.

NOTE: Many Allmand light towers designed for use outside North America operate at 230 volts/

50 Hz. Testing is done the same way following the above instructions. If you are unsure which

voltage your light tower is designed to produce contact a qualified electrician for assistance.

Figure A.1