Allmatic AM900ECO 설치 매뉴얼 - 페이지 4
{카테고리_이름} Allmatic AM900ECO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic AM900ECO 8 페이지. Programmable control unit for rolling shutters
페이지 인쇄
6. Learnings
6.1 Learning a transmitter through the "RADIO LEARN" key of the control unit
Button "UP"
6.1.1 Learning of a two buttons transmitter
STOP THE
AUTOMATION
Press and release the UP button of the transmitter. The
buzzer emits a short beep.
Wait few seconds for the automatic learning of the DOWN
button. Otherwise press and release the DOWN button of
the transmitter. The buzzer emits a short beep followed by
two long and two short beeps.
6.1.2 Learning of a three buttons transmitter
STOP THE
AUTOMATION
Press and release the STOP button of the
transmitter . The buzzer emits a short beep
Press and release the DOWN button of the
transmitter . The buzzer emits a short beep
Press and release the DOWN button of the
transmitter . The buzzer emits a short beep
followed by two long beeps and two short ones.
6-1622601 REV.02
22/09/2021
Button "DOWN"
Press and release the RADIO LEARN
button. The buzzer emits long beeps each
second
YES
SI
SI
The 2 buttons are learnt and the
procedure
finishes.
Repeat
procedure if you wish to learn a new
transmitter.
Press and release the RADIO
LEARN button. The buzzer
emits some long beeps each
second.
SI
SI
SI
SI
The 3 buttons have been learnt and
the procedure finishes. Repeat the
procedure if you wish to learn a new
transmitter.
ITA
Button "UP"
Check that the automation is still.
NO
If the buzzer emits a long bip and two short ones, the
NO
transmitter was already been memorized. If the buzzer
does not make any signal verify that the transmitter
works and belongs to the B.ro Series
If the buzzer does not emit any signal, repeat the
NO
procedure with another transmitter.
the
Check that the automation is still.
NO
If the buzzer emits one long bip and two short ones, the transmitter
was already been learnt. If the buzzer does not make any signal
NO
check that the transmitter works and belongs to the B.ro. Series.
If the buzzer does not emit any signal, repeat the
NO
procedure with another transmitter.
If the buzzer does not make any signal, repeat the
NO
procedure with another transmitter.
ENG
FRA
ESP
DEU
POR
Button "STOP"
Button "DOWN"
4 / 8