Miele CS 1028 변환 지침 - 페이지 13

{카테고리_이름} Miele CS 1028에 대한 변환 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele CS 1028 40 페이지. Combiset
Miele CS 1028에 대해서도 마찬가지입니다: 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지), 작동 및 설치 지침 (44 페이지)

페이지 인쇄

The cooktop should have been ordered

for connection to either natural or LP

(propane) gas.

The included regulator corresponds

with the gas type of the cooktop. Verify

before installing. See, "To convert the

regulator".

If the appliance is to be connected to a

type of gas other than it was originally

configured for, both the regulator and

burners must be converted.

WARNING

The conversion kit must be

installed by a qualified technician

in accordance with the

manufacturer's instructions and

all applicable local and national

codes. If the information in these

instructions is not followed

exactly, a fire, explosion or

production of carbon monoxide

may result causing property

damage, personal injury or loss of

life. The qualified technician is

responsible for the proper

installation of this kit. The

installation is not proper and

complete until the operation of the

converted appliance is checked as

specified in these instructions.

Converting CS 1028

To convert the regulator:

^ Unscrew the hexagonal nut (brass

cap) located on the top of the

regulator.

^ Make sure that the spring stays in

place.

^ Take the plastic insert out and flip it

over.

The plastic insert is marked on either

end:

- NAT (Natural Gas)

- LP (Propane)

^ Set the plastic insert back into the

nut.

^ Screw the hexagonal nut back on the

regulator.