Allmatic CT INVERTER AM 설치 매뉴얼 - 페이지 12

{카테고리_이름} Allmatic CT INVERTER AM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic CT INVERTER AM 12 페이지. Programmable control board for sliding gates with inverter technology

페이지 인쇄

Avoid putting the connection cables of buttons, security devices and inputs close to those of the power supply of the control unit and of the motor. Some

parts of the control unit are subject to dangerous voltage. The control unit must be installed and programmed only by qualified professionals. Always use

a device that ensures the disconnection of all poles of the control unit's power supply .

This device can be a switch (connected directly to the power supply terminals) with a contact's minimum distance of 3 mm for each pole, or it can be a

device connected to the power network.

For connecting the card and the motors we recommend to use cables with double isolation as in compliance to the laws in force; the minimum cross

section of the single conductor must not be less than 1,5 mm² and not more than 2.5mm².

Power supply

Photocells power supply

Accessories power supply

Motor output

Flashing light output

Courtesy light output

Auxiliary output (only with card R1). Clean contact out-

put NOT supplied.

GUARANTEE - In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the re-

pair or free replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The

guarantee does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect

product, assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired.

Printed specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environ-

mental interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective

products, are only those responsibilities that come under Italian law.

6-1622595

rev.06

13/01/2017

WARNING AND ADVICES

TECHNICAL FEATURES - CT INVERTER AM

230 Vac +15%, -15% ; 50Hz

24 Vdc 3W MAX

24Vac 3W MAX

230Vac 1,5KW (current limited to 10A) MAX cos > 0.8

230 Vac 60W MAX for fixed light, without self-blinking.

230Vac 100W MAX

24Vac 0.5A MAX (12W MAX)

ALLMATIC S.r.l

32020 Lentiai - Belluno – Italy

Via dell'Artigiano, n°1 – Z.A.

Tel. 0437 751175 – 751163 r.a.

http://www.allmatic.com - E-mail: [email protected]

ITA

ENG

Fax 0437 751065

FRA

ESP

DEU

POR

12 / 12