Miele DA 186 작동 및 설치 지침 - 페이지 12

{카테고리_이름} Miele DA 186에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 186 28 페이지. Cooker
Miele DA 186에 대해서도 마찬가지입니다: 작동 및 설치 지침 (28 페이지), 작동 및 설치 지침 (28 페이지), 작동 및 설치 지침 (28 페이지), 작동 및 설치 지침 (36 페이지)

페이지 인쇄

Cleaning and care

Before any cleaning or

maintenance work is carried out,

disconnect the rangehood from the

mains supply. Ensure that:

– it is switched off at the isolator,

– it is switched off at the wall

socket and the plug removed, or

– the fuse is withdrawn from the

fused spur connection unit, or

– the mains fuse is withdrawn, or

– the screw-out fuse is removed

(in countries where this is

applicable).

Exercise caution when changing

halogen lamps. They get very hot

during use, and remain hot for some

time after being switched off. Do not

touch the surface directly when

changing a lamp, as grease particles

from your fingers will adhere to the

surface and damage it.

The halogen lamps can also be

damaged if water is used to clean

them.

Wait several minutes after switching

off before beginning cleaning.

Housing

The surfaces and controls are

susceptible to scratches and

abrasion. Please observe the

following cleaning instructions.

All external surfaces and controls can

be cleaned using warm water with a

small amount of washing-up liquid

applied with a well wrung-out soft

sponge or cloth.

Wipe the surfaces dry using a soft cloth.

Do not use too much water when

cleaning the controls. Water could

penetrate into the electronics and

cause damage.

Do not use:

– cleaning agents containing soda,

acids, chlorides or solvents,

– abrasive cleaning agents, e.g.

powder cleaners or cream cleaners

and abrasive sponges, as well as pot

scourers or sponges which have

been used previously with abrasive

cleaning agents. These will damage

the surface material.

Grease filters

The re-usable metal grease filters in the

appliance remove solid particles

(grease, dust, etc.) from the kitchen

vapours, preventing soiling of the

rangehood.

To avoid a build-up of fat, it should be

cleaned every 3-4 weeks on average,

but sooner if necessary.

An oversaturated filter is a fire

hazard.