Miele DA 2360 작동 및 설치 지침 - 페이지 31

{카테고리_이름} Miele DA 2360에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 2360 36 페이지. Ventilation system
Miele DA 2360에 대해서도 마찬가지입니다: 작동 및 설치 지침 (40 페이지), 작동 및 설치 지침 (40 페이지), 작동 및 설치 지침 (36 페이지), 작동 및 설치 지침 (40 페이지), 작동 및 설치 지침 (36 페이지)

페이지 인쇄

Air venting

WARNING: Danger of toxic fumes.

Gas cooking appliances release

carbon monoxide that can be

harmful or fatal if inhaled.

To reduce the risk of fire and to

properly exhaust air, the exhaust

gases extracted by the hood should

be vented outside of the building

only.

Do not vent exhaust air into spaces

within walls or ceilings or in attics,

crawl spaces or garages.

To reduce the risk of fire, only use

metal ductwork.

Please read and follow the

"IMPORTANT SAFETY

INSTRUCTIONS" to reduce the risk

of personal injury. Follow all local

building codes when installing the

hood.

Only use smooth pipes or flexible

ducting made from approved non-

flammable materials for ducting.

To achieve the most efficient air

throughput with the lowest noise levels,

please note the following:

- The diameter of the vent ducting

must not be smaller than the cross-

section of the vent collar (see

"Appliance dimensions"). This applies

in particular when using flat ducting.

- The ducting should be as short and

straight as possible.

- Only use wide radius bends.

- The ducting must not be kinked or

compressed.

- All connections must be strong and

airtight.

- If the ducting has flaps, these must

be opened whenever the ventilation

hood is switched on.

Any constriction of the air throughput

will reduce extraction performance

and increase operating noise.

Ventilation stack

If the exhaust air is to be ducted into a

flue, the ducting must be directed in the

flow direction of the flue.

If the flue is used by several ventilation

units, the cross-section of the flue must

be large enough.

Non-return flap

 Use a non-return flap in the vent

system.

A non-return flap ensures that when the

ventilation hood is not in operation, the

duct is closed to prevent unwanted

exchange of room air and outside air.

If the exhaust is ducted through an

outside wall, a Miele wall vent or roof

vent (available as an optional

accessory) is recommended. Both of

these have a built-in non-return flap.

Installation