Miele DA 272 i 사용 설명서 - 페이지 18
{카테고리_이름} Miele DA 272 i에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 272 i 28 페이지.
페이지 인쇄
Installation
Installation
Lift the cooker hood into the unit
from below until the lugs of the
brackets lie above the support
tracks. Then carefully lower the
cooker hood. The lugs engage with
the support track.
To align the height, turn the
M 6 x 19 mm adjuster screws clock-
wise or anti-clockwise.
Move the cooker hood into its
correct position.
Secure the cooker hood on both
sides using four 3 x 16 mm
( 5/8 ")screws for each side.
18
Feed the air extraction or air re-circu-
lation connector through as applic-
able, (see chapter "Air extraction" /
"Air re-circulation").
Replace the dividing wall in the wall
unit.
Pull the deflector plate out to its limit
and remove the grease filters.
4 holes (DA 262 i / DA 272 i) or
6 holes (DA 292 i) are now visible.
Use a sharp pointed instrument
through these holes to gouge out the
fixing holes.
Then screw the cooker hood se-
curely to underside of wall unit.
Replace the grease filters.
Depth alignment
Units deeper than 285 mm require the
fitting of a spacer bar to prevent va-
pours collecting between the rear of
the cooker hood and the wall.
2
1
To achieve the correct depth shorten
the . . .
. . . spacer bar at the required break-
ing points.
. . . End caps.
Fit the end caps (1) to both ends of
the spacer bar.
1