Miele DA 3060 운영 및 설치 매뉴얼 - 페이지 29

{카테고리_이름} Miele DA 3060에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 3060 36 페이지. Cooker
Miele DA 3060에 대해서도 마찬가지입니다: 작동 및 설치 지침 (36 페이지)

페이지 인쇄

Important: To avoid the danger of

toxic fumes, please observe the

Warning and Safety instructions.

This is especially crucial when using

the cooker hood at the same time as

another heating appliance which

relies on air from the same room.

The cooker hood should be installed

according to local and national

building regulations. Seek approval

from the building inspector where

necessary.

– Only use smooth pipes or flexible

hoses made from non-flammable

materials for the extraction ducting.

To achieve the greatest possible air

extraction with the lowest noise level,

please note the following:

– To ensure efficient air extraction, the

diameter of the exhaust ducting

should not be less than 150 mm.

– If flat ducting is being used, the

cross-sectional area must not be

smaller than the cross-sectional area

of the exhaust connection.

– All ducting, pipework and fittings

must be of non-flammable materials.

– The exhaust ducting should be as

short and straight as possible.

– Only use wide radius bends.

– The exhaust ducting should not be

kinked or compressed.

– Ensure that all connections are

strong and airtight.

Connection for air extraction

– Where ducting is horizontal, it must

be laid to slope away at at least 1 cm

per metre. This is to ensure that

condensate cannot drain back into

the cooker hood.

– If the exhaust air is to be ducted into

the open air, the installation of a

telescopic wall vent or roof vent

(available as an optional accessory)

is recommended.

– If the exhaust air is to be ducted into

a vent flue, the ducting must be

directed in the flow direction of the

flue.

Important:

If the exhaust ducting is to run through

rooms, ceiling space etc. where there

may be great variations in temperature

between the different areas, the

problem of condensation will need to

be addressed. The exhaust ducting will

need to be suitably insulated.