Miele DA 5391 W 운영 및 설치 매뉴얼 - 페이지 18

{카테고리_이름} Miele DA 5391 W에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DA 5391 W 40 페이지. Miele ventilation system operating and installation instructions
Miele DA 5391 W에 대해서도 마찬가지입니다: 작동 및 설치 지침 (36 페이지), 제품 치수 (2 페이지), 작동 및 설치 지침 (36 페이지)

페이지 인쇄

Cleaning and Care

Grease filters

The reusable metal grease filters

remove solid particles from the vented

kitchen air (grease, dust, etc).

The grease filters should be cleaned

every 3 - 4 weeks or when the grease

filter indicator lights.

A dirty filter is a fire hazard.

^ To remove the grease filters pull the

locking clips, 1, forward. Lower the

filter 45°, 2, unhook it at the rear, 3,

and take it out. Support the grease

filter so that it does not fall onto the

cooktop.

Cleaning the grease filter

^ By hand: use a scrub brush with a

solution of warm water and mild

detergent.

Do not use the pure detergent,

aggressive all purpose cleaners,

oven sprays, abrasive cleaning

agents or limescale removers. They

could destroy the filter.

^ In a dishwasher: place the filter

vertically in the lower basket, making

sure that the spray arm is not

blocked.

Use a wash program with a max.

temperature of 150°F (65°C). In a

Miele dishwasher use the "Normal"

program.

Use the recommended amount of

dishwasher detergent. Overuse could

destroy the filter.

Depending on the detergent,

cleaning the grease filters in a

dishwasher may cause permanent

discoloration of the filter surface.

Performance of the filter will not be

affected by this discoloration.

^ After cleaning, the filters can be

placed on a towel to air dry.

^ While the filters are removed, clean

any dirt or grease from the filter

casing to prevent the risk of fire.

When putting the grease filters back

make sure that the locking clips are

visibly facing the cooking surface.

If the filters are incorrectly installed,

insert a small screwdriver into the slit

along its edge to disengage it from the

casing.

^ After returning the grease filters,

press and hold the grease filter

button for 3 seconds to reset the

timer. The indicator light will go out.

^ If the grease filters are cleaned

before the grease filter timer has

reached its maximum, press the

grease filter button for 6 seconds to

reset the counter to zero.