Miele DAG 1000 작동 및 설치 지침 - 페이지 9

{카테고리_이름} Miele DAG 1000에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DAG 1000 16 페이지. External blower
Miele DAG 1000에 대해서도 마찬가지입니다: 작동 및 설치 지침 (40 페이지)

페이지 인쇄

Preparation

^ Remove all packaging.

^ Unscrew and remove the six screws

on the blower cover.

^ Unscrew the two screws on the

terminal box and remove the cover.

Install a UL/CSA-approved cable

clamp in the power cord

feed-through (strain relief). Locate it

so that it is accessible from the

blower.

^ Close the terminal box and the

replace the blower cover.

Installation on an external wall

Select a suitable installation location.

– Make sure that there are no

supporting elements in the wall at the

selected location. The same applies

for power cords and pipes.

– Install the external blower with the

exhaust outlet facing downwards.

– The distance between the exhaust

outlet and the ground must be at

least 24" (61 cm).

^ The external blower must be installed

on a level surface.

If necessary, remove the wall

covering at the installation location.

^ Make an 11" hole (28 cm) for the

exhaust duct and a hole for the

power cord 1 ¼" (3 cm).

^ Apply a sealant along the outside

edge on the rear wall of the blower

housing.

^ Mount the external blower on the

external wall using four suitable

screws.

^ Seal the screw heads.

Installation on a roof

Select a suitable installation location.

– The angle of the roof must be at least

10°.

For installation on a flat roof, consult

a qualified contractor.

– Make sure that there are no

supporting elements in the roof at the

installation location. The same

applies for power cords and pipes.

– The exhaust outlet must face down

and away from the main wind

direction.

Installation