Miele DAR 1220 작동 및 설치 지침 - 페이지 6

{카테고리_이름} Miele DAR 1220에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DAR 1220 32 페이지. Range wall / insert hood
Miele DAR 1220에 대해서도 마찬가지입니다: 작동 및 설치 지침 (22 페이지), 작동 및 설치 지침 (40 페이지), 작동 및 설치 지침 (40 페이지)

페이지 인쇄

IMPORTANT SAFETY INSTRUCTIONS

Installation

,WARNING

TO REDUCE THE RISK OF

FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

a) Installation work and electrical

wiring must be done by qualified

person(s) in accordance with all

applicable codes and standards,

including fire-rated construction.

b) Sufficient air is needed for

combustion and exhausting of gases

through the flue (chimney of fuel

burning equipment to prevent back

drafting. Follow the heating equipment

manufacturer's guideline and safety

standards such as those published by

the National Fire Protection Association

(NFPA) and the American Society for

Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and

the local code authorities.

c) When cutting or drilling into the

wall or ceiling, do not damage electrical

wiring and other hidden utilities.

d) Ducted hoods must always be

vented to the outdoors.

e) Do not use this hood with any

solid-state speed control device.

f) Do not use an extension cord to

connect the appliance to electricity.

Extension cords do not guarantee the

required safety of the appliance,

(e.g. danger of overheating).

g) Do not install this hood over

cooktops that burn solid fuel.

h) Provided a larger distance is not

given by the manufacturer of the

cooktop, follow the minimum safety

distances between a cooktop and the

bottom of the hood given in the

"Appliance dimensions" section of this

manual.

If local building codes require a greater

safety distance, follow their

requirement.

If there is more than one appliance

beneath the hood and they have

different minimum safety distances

always select the greater distance.

i) Never connect an exhaust hood to

an active chimney, dryer vent, vent flue,

or room ventilating ductwork.

j) Seek professional advice before

connecting an exhaust hood vent to an

existing, inactive chimney or vent flue.

k) Any fittings, sealant, or materials

used to install the ductwork must be

made of approved non-flammable

materials.

l) This hood should only be used in

combination with the DRIB XL/XXL or

DREB XL/XXL Miele Blower.

,WARNING

TO REDUCE THE RISK OF

FIRE USE ONLY METAL

DUCTWORK.