Miele DAW 1620 Active 작동 및 설치 지침 - 페이지 28

{카테고리_이름} Miele DAW 1620 Active에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele DAW 1620 Active 36 페이지.

Installation

Condensation

If the exhaust ducting is to run through

cool rooms or ceiling space, for ex-

ample, the significant variations in tem-

perature between the different areas

can cause condensation to form. Insu-

late the exhaust ducting to reduce tem-

perature variations.

If the exhaust ducting is to be laid hori-

zontally, it must be laid with a down-

wards sloping gradient of at least 1 cm

per meter. This is to ensure that con-

densation cannot drain back into the

cooker hood.

In addition to insulating the exhaust

ducting, it is advisable to also install a

condensate trap for collecting and

evaporating any potential condensation.

Condensate traps for 125 mm or

150 mm diameter exhaust ducting are

available as optional accessories.

When installing a condensate trap, en-

sure that it is positioned vertically and

as closely as possible to the cooker

hood above the exhaust connection.

The arrow on the casing indicates the

direction of airflow.

Miele shall not accept warranty claims

for any functional defects or damage

caused by inadequate exhaust duct-

ing.

To reduce noise levels even further, a si-

lencer (optional accessory) can be in-

stalled in the exhaust ducting.

In extraction mode, the silencer not only

reduces noise from the fan outside the

house, but also sounds originating out-

side reaching the kitchen through the

exhaust ducting (e.g. traffic noise). For

this reason, the silencer must be posi-

tioned as close as possible to the duct-

ing exit .