Allmatic B.RO MINI 1CH 매뉴얼 - 페이지 4

{카테고리_이름} Allmatic B.RO MINI 1CH에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic B.RO MINI 1CH 8 페이지. Programmable radio receiver, single relay output.
Allmatic B.RO MINI 1CH에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)

페이지 인쇄

3. FIRST INSTALLATION

Once the device is installed, before you can use it you need to power it and wait for the LED to flash two flashes.

Power the receiver, the LED performs two flashes.

Once the LED is turned off, the receiver is ready to be used.

4. LEARNING OF A TRANSMITTER

The B.RO MINI 1CH is compatible with all Rolling Code Allmatic transmitters. Before learning a new remote control make sure that

the type of transmitted code is compatible with that of the receiver in use and move close to the receiver itself.

Make sure the receiver is powered and ready to use (LED off).

Once press the learning button, the LED lights up.

Press the button of the transmitter you want to store.

The LED will flash two times to confirm the correct storage of the remote control.

Repeat the procedure for each transmitter you want to store.

Warning: After 10 seconds of inactivity the device automatically exits the programming menu.

Attention: The receiver stores only one button per transmitter. If a second key is stored, it will replace the previously

stored key.

KEY:

4 - English

= LED Off;

= LED On Fixed;

= flashing LED

6-1620051 - rev.8 - 30/09/2021

2 x