Allmatic B.RO X40 DISPLAY 매뉴얼 - 페이지 10
{카테고리_이름} Allmatic B.RO X40 DISPLAY에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic B.RO X40 DISPLAY 20 페이지. 4 channels rolling code receiver, with display
페이지 인쇄MENU
REMOVAL OF THE TRANSMITTER
deL
It allows the removal of the single transmitter.
ENABLING OF THE TRANSMITTER
enab
It allows to enable or disable the transmitter.
MOVING OF THE TRANSMITTER
move
It allows to move the location where the transmitter has been
registered in the memory.
BUTTONS PERSONALISATION
By selecting the button (b01, b02, ..., b15, b16) it is possible:
•
to associate the output function (FUnCT):
- F00: Dead Man;
btn
- F01: Step by Step;
- F02: Timed;
- F03: Timed+delay.
•
to associate output channels (CH01, CH02, CH03, CH04).
4.2.1 deL - REMOVAL OF THE TRANSMITTER
By accessing the item deL it is possible to delete the single transmitter from the receiver.
In order to proceed with the removal, move to the item deL and then confi rm by a long pressure of the MENU button. Keep pressed
until the display shows the value 0, then release the button. Hold again the MENU button: a countdown starts d20, d19, ..., d1, d0.
Once the countdown ends, the reset has successfully been performed, and the display shows
4.2.2 enAb - ENABLING OF THE TRANSMITTER
It allows to enable or disable the single transmitter. This function serves to disable the transmitter during a period of time, without
removing it from the memory and thus maintaining the confi gured characteristics.
4.2.3 Move - MOVING OF THE TRANSMITTER
It allows to move the position of the transmitter in the receiver's memory.
In order to proceed with the change, move to the item Move, then confi rm with a long pressure of the MENU button. Keep pressed
until the display shows the fi rst free position (e.g. p000), then release the button. The positions of the memory occupied by a
transmitter are indicated by the presence of a point between the digits (for example P0.0.1).
Use the UP (+) and DOWN (-) buttons to select the desired position and confi rm by a long pressure of the MENU button. Keep
pressed until the display shows the value Moved, then release the button.
4.2.4 btn - BUTTONS PERSONALISATION
It allows to personalize the transmitter's single button. It is possible to associate the function and the output channels (even more
than 1) to each transmitter's button.
Please follow the procedure below to proceed with the changes:
Select the button to modify with the UP (+) and DOWN (-) buttons of the receiver.
10/20
DESCRIPTION
Press and hold the MENU button until the display shows:
If the key was already saved, the display can show the function previously
Select the desired function with the UP (+) and DOWN (-) buttons.
ITA
ENG
The display shows:
-
assigned:
FRA
ESP
DEU
POR
SELECTABLE
VALUES
DEFAULT
min-max
ON-OFF
ON
000-999
.
6-1620020
rev.0
UNIT
27/10/2015