HP 117755-003 - ProSignia - 740 구현 매뉴얼 - 페이지 30

{카테고리_이름} HP 117755-003 - ProSignia - 740에 대한 구현 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 117755-003 - ProSignia - 740 35 페이지. Memory technology evolution: an overview of system memory technologies, 8th edition
HP 117755-003 - ProSignia - 740에 대해서도 마찬가지입니다: 오류 방지 매뉴얼 (12 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 개요 (20 페이지)

페이지 인쇄

Issue 11

Using the F6 key to install HP drivers

Description

Solution

Issue 12

Special installation procedures for HP storage drivers

Description

Solution

Feature implementation

A few system configurations may require additional user action to complete the installation. Some

value-added features are implemented differently under Windows 2000 than they were under

Windows NT 4.0

Table 10. Windows 2000 feature implementation issues

Issue 13

COM 3 might display as a not supported device

Description

Solution

Press the F6 key to interrupt the text mode setup and install OEM-supplied

drivers at the prompt:

Press F6 to install a third-party SCSI or RAID driver.

However, HP drivers loaded through this procedure will be replaced with the

drivers on the Windows 2000 CD during installation.

Unless otherwise instructed, continue using the driver versions on the Windows

2000 CD during the setup process, then upgrade to the latest HP drivers

supplied on PSP for Windows 2000. The manufacturer should address third-

party hardware drivers and their installation.

After the system has been rebooted following the initial installation of the PSP

for Windows 2000, event notification drivers for storage devices are installed

by performing a second PSP installation.

Check the hardware documentation to determine which driver is required for

operation of the controller.

The HP ProLiant Storage System Plug and Play device (for SCSI event reporting),

the Drive Array Event Notification device (for array event reporting), and the HP

Smart Array 5x Notification device are not visible under Device Manager until

all HP SCSI and RAID (miniport) drivers are installed. The first pass installs the

HP drivers CPQ32FS2.SYS or ADPU160M.SYS (for SCSI), CPQARRAY.SYS (for

older array controllers) or CPQARRY2.SYS or CPQCISSM.SYS (for newer array

controllers).

To complete the install, run the PSP a second time, during which the drivers

PRLNTSS.SYS, CPQDAEN.SYS, and CPQCISSE.SYS will be properly loaded.

After Windows 2000 is installed on a server with the HP 56K Netelligent ISA

internal modem installed, COM 3 might be displayed as an unsupported device

in Device Manager. The Device Status message says:

This device cannot start. (Code 10)

This also shows up as a problem device under the Computer Management

snap-in, under System Information | Components | Problem Devices.

The modem functions, when set to Plug and Play Mode, even if Windows 2000

displays COM 3 as unsupported.