HP 124708-001 - ProLiant Cluster - 1850 오류 방지 매뉴얼 - 페이지 12

{카테고리_이름} HP 124708-001 - ProLiant Cluster - 1850에 대한 오류 방지 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 124708-001 - ProLiant Cluster - 1850 12 페이지. Proliant essentials foundation pack installation guide
HP 124708-001 - ProLiant Cluster - 1850에 대해서도 마찬가지입니다: 구현 매뉴얼 (35 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 개요 (20 페이지), 구현 매뉴얼 (26 페이지), 소개 매뉴얼 (22 페이지), 문제 해결 매뉴얼 (18 페이지), 구현 매뉴얼 (11 페이지), 설치 매뉴얼 (2 페이지)

페이지 인쇄
HP 124708-001 - ProLiant Cluster - 1850 오류 방지 매뉴얼

Cleaning Drives

DAT Drives

Clean the tape heads of the drive regularly with a cleaning cartridge to maintain the
integrity of backup data. For optimum performance and to prevent the loss of data,
HP recommends that you incorporate a cleaning cycle into your backup routine.
As a general guideline, you should clean the tape heads after every fifth backup
cartridge. You should also clean the tape heads if the media caution signal (flashing
amber light) is displayed on a tape drive or the
autoloader. Refer to the device documentation for more information.
Cleaning Cartridges
Use only an HP cleaning cartridge to clean the tape heads. Do not use swabs or other
means of cleaning the heads. The cleaning cartridge uses a special tape to clean the
tape heads. A cleaning cartridge can only be used 50 times or as instructed on the
cartridge packaging. When the cartridge runs out of tape, discard it and use a new
one.

LTO, SDLT, and DLT Drives

Use the cleaning cartridge if cleaning is indicated by the backup software or if the
Cleaning LED is on. Refer to the device documentation for more information.

AIT Drives

The tape drive has a cleaning roller built in, which assists in preventing and
recovering from head contamination. This feature minimizes buildup on the
read/write heads so fewer cleaning cycles with a cleaning cassette are required.
However, HP recommends you schedule a routine cleaning every 100 hours of use to
keep the tape drive in good working order. The drive also needs cleaning when the
drive Status LED displays long flashes with short pauses. Refer to the device
documentation for more information.
Error Prevention Guide
message is displayed on an
Clean Me
13