Miele PT 8257 WP 작동 및 설치 지침 - 페이지 5

{카테고리_이름} Miele PT 8257 WP에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele PT 8257 WP 36 페이지.
Miele PT 8257 WP에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지)

페이지 인쇄

1. Technical Data

Technical and electrical safety

The dryer must be installed and tested by Miele's

Technical Service Department or an authorized dealer.

The electrical safety of this appliance is only assured if it

is connected to a grounding system. Is is very important to

make sure that this essential safety requirement is met. If in

doubt have the house wiring system checked by a qualified

electrician. The manufacturer will not be held liable for

damage caused by a missing or improperly connected

ground wire.

The dryer is disconnected from the power supply only

when it is unplugged or when the main breaker or the

dryer's breaker at the building's electrical service panel is

switched off.

Unprofessional repairs may create unforeseeable risks

for the user, for which Miele assumes no liability. Repairs

should be carried out only by authorized Miele technicians

- otherwise, associated damage will not be covered by the

warranty.

Defective components must be replaced with genuine

Miele spare parts only. Only with these parts can we

guarantee that the safety requirements of our appliances

are met.

Do not operate the dryer in a room where cleaning

machines operate with solvents containing CFC. Vapors

from combustion turn into hydrochloric acid which

damages laundry and dryer. When operated in a separate

room, there must be no air exchange.

Make sure the dryer is supplied with clean fresh air only,

not air containing chlorine, fluorine or other solvent vapors.

The cool air intake opening is located on the back of the

dryer, while the exhaust air opening is located on the

cover. Never block these openings. Therefore, do not cover

the top of the dryer with any type of blankets, sheets or

boxes (see installation instructions).

Never use or store gasoline, petroleum-based

substances or other easily flammable substances near the

machine. Fire and explosion hazard!

The dryer needs timely and professional maintenance to

prevent performance loss, malfunctions and the risk of fire.

IMPORTANT SAFETY INSTRUCTIONS

Use of the appliance

The dryer is only intended for drying fabrics that

were washed with water as a cleaning agent.

Operate the dryer only if an exhaust air duct is

connected and the room is adequately ventilated.

The dryer may be operated only if the heat pump

module is hooked up and connected to the dryer.

Sufficient ventilation must be ensured (see the installation

instructions).

Make sure that the heat pump is correctly connected to

the dryer without any gaps. It must not be possible to reach

between the two machines - risk of injury!

Persons who lack physical, sensory or mental abilities,

or experience with the appliance should not use it without

supervision or instruction by a responsible person.

Do not let children play in, on or near the dryer. Do not

let them play with the controls or operate the unit.

Make sure that no unattended children can access the

machine. There is a potential danger that children can be

trapped in the drum. This may cause major injuries or the

death of the child.

Do not operate the appliance if the control panel, wires

or cables are damaged.

Do not damage, remove, or bypass any of the safety

features and controls of the dryer.

Do not operate the dryer when housing parts have been

removed and the moving or electrical parts are exposed

and accessible.

High temperatures occur at the window and frame of

the drum door, and the laundry is extremely hot if it is

removed too soon.

Always make sure the drum is stationary before

reaching in to remove laundry. Never put your hand into a

drum that is still moving.

Take care not to pinch or cut your fingers on the hinges

of the drum door or lint flap and on the maintenance cover

on the back of the dryer. Use the handles and quick

release fasteners. Beware of any potential hazardous areas

when installing the dryer and heat pump.

The area necessary to open the drum door completely

must not be obstructed by doors or other structures.