HP 179310-001 - Deskpro EN - 6350X Model 6400 CDS 시작하기 - 페이지 7

{카테고리_이름} HP 179310-001 - Deskpro EN - 6350X Model 6400 CDS에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 179310-001 - Deskpro EN - 6350X Model 6400 CDS 29 페이지. Hp deskpro ap750: quick start

페이지 인쇄

Method 2 (Manually Converting to NTFS)

1-4

Getting Started with Software

Before you manually convert to NTFS, you must have the

following:

A bootable MS-DOS diskette (OSR2 or later) having IDE

CD support or network support and containing the following

MS-DOS utilities: FDISK, FORMAT, and XCOPY.

Microsoft Windows NT Workstation 4.0 installation CDs

and the Service Pack 4 CD, or appropriate network share.

Appropriate Compaq device drivers, located at

www.compaq.com.

1. Insert the bootable MS-DOS diskette into the diskette drive

and turn on or restart the computer.

2. At the MS-DOS Prompt, run FDISK and press Enter.

3. When prompted, select large drive support.

4. From the FDISK main menu, select "Delete partition or

logical DOS drive" (Option 3) and press Enter.

5. Select the appropriate option(s) to delete existing partitions

or logical drives. The order in which FDISK will allow

deletion is as follows:

A) Logical drives lowest drive letter first (d: ... z:).

B) Extended partition(s)

C) Primary partition

D) Non-DOS partition(s) (at any time)

After completing steps 1-5, install the operating system as

described in the following section.