HP 18-1200 빠른 설정 매뉴얼 - 페이지 14

{카테고리_이름} HP 18-1200에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 18-1200 21 페이지. Quick setup guide
HP 18-1200에 대해서도 마찬가지입니다: 빠른 시작 (1 페이지), 매뉴얼 (13 페이지), 시작하기 매뉴얼 (25 페이지)

페이지 인쇄
HP 18-1200 빠른 설정 매뉴얼

Keyboard and mouse (wireless)

Symptom
Possible solution
Wireless keyboard
●
or mouse does not
work or is not
detected.
●
●
●
The receiver, wireless keyboard, and wireless mouse shown in the following illustrations
are examples; your models might vary. IMPORTANT: During these steps, place the
wireless keyboard and wireless mouse on the same level as the receiver, within 30 cm (12
inches) of the receiver, and away from interference from other devices.
1.
2.
3.
4.
10
Chapter 5 Troubleshooting
Ensure that you are using the wireless keyboard or wireless mouse within range of the
receiver, approximately 10 meters (32 feet) for normal use, and within 30 cm (12
inches) during initial setup or for re-synchronization.
Ensure that the mouse is not in Suspend mode, which occurs after 20 minutes of
inactivity. Click the left mouse button to reactivate it.
Replace the batteries in the keyboard and mouse.
Re-synchronize the keyboard and mouse to the receiver using the following steps.
Unplug the receiver from a USB connector on the computer, and then reconnect it.
Your computer model might have a connector dedicated to the receiver. If you have a
choice, use a USB connector on the front of the computer.
Check that the mouse is on (A), and push and hold the Connect button (B) on the
underside of the mouse for 5 to 10 seconds until the LED on the receiver lights or
stops flashing. The receiver connection session times out after 60 seconds. To ensure
that the connection was established, and that the receiver did not time out instead,
move the mouse and check for response on the screen.
B
A
Off
Connect
On
After the mouse connection is established, continue by using the steps that follow to
repeat the procedure for the keyboard.
Push and hold the Connect button (C) on the underside of the keyboard for 5 to 10
seconds until the LED on the receiver lights or stops flashing.
C
ENWW