HP 226824-001 - ProLiant - ML750 구현 매뉴얼 - 페이지 18

{카테고리_이름} HP 226824-001 - ProLiant - ML750에 대한 구현 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 226824-001 - ProLiant - ML750 26 페이지. Visualization and acceleration in hp proliant servers
HP 226824-001 - ProLiant - ML750에 대해서도 마찬가지입니다: 자주 묻는 질문 (4 페이지), 구현 매뉴얼 (35 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 개요 (20 페이지), 소개 매뉴얼 (22 페이지), 문제 해결 매뉴얼 (18 페이지), 구현 매뉴얼 (11 페이지), 설치 매뉴얼 (2 페이지), 구성 매뉴얼 (2 페이지), 소개 매뉴얼 (19 페이지), 업데이트 매뉴얼 (9 페이지), 업데이트 매뉴얼 (16 페이지), 소개 매뉴얼 (12 페이지), 소개 매뉴얼 (10 페이지), 기술 개요 (9 페이지)

Windows Server 2008 installation for 32-bit and 64-bit

editions on ProLiant servers

Server deployment of Windows Server 2008 is supported through manual and assisted path

installation options. Use the steps below to complete a manual install of Windows Server 2008.

To prepare for installation, ensure that the following conditions are met:

The server selected for installation is listed as a recommended system platform in Table 2.

Any additional storage options added to the server are listed as a supported ProLiant storage

options in Table 4.

Any additional NICs added to the server are listed as a supported ProLiant Gigabit Ethernet NIC

in Table

Go to

www.hp.com/go/bizsupport

installations for the server.

Use the ROM-Based Setup Utility (RBSU) to set date/time and configure the boot controller order

(if necessary).

Use the Array Configuration Utility to configure the RAID settings for the server.

Install the HP Insight Management Agents only after SNMP is loaded and started.

NOTE

After installing Windows Server 2008 and before installing

the PSP, if installing HP Systems Insight Manager and agents,

be sure that SNMP is loaded and the service is started.

Update iLO 2 firmware to Version 1.29 (or later).

To install the Windows Server 2008 installation (for 32-bit and 64-bit editions), complete the

following steps:

Make sure that the server has a DVD drive (either native to the system or attached).

NOTE

A license key may be required to use iLO virtual media with HP

ProLiant ML or HP ProLiant DL servers.

Place the Windows Server 2008 media into the DVD drive and boot the server to the DVD to

begin the installation.

to obtain the supported ROM for Windows Server 2008