Miele T 1526 기술 정보 - 페이지 30

{카테고리_이름} Miele T 1526에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1526 42 페이지. Vented dryer
Miele T 1526에 대해서도 마찬가지입니다: 운영 매뉴얼 (28 페이지), 운영 매뉴얼 (28 페이지)

페이지 인쇄

Technical Information

1. Open the front panel; see Section 5.2 or 5.3.

2. Locate the heater relay bracket on the right-hand vertical section of the frame.

3. Remove the securing screw; lift the bracket from the frame.

4. Position the bracket to allow access to the relay(s).

5. Slide each relay from the bracket to release.

5.7

Drum Rear Panel Removal

1. Open the front door of the dryer.

2. Turn the drum by hand so that the two larger holes are horizontally across

from each other; refer to Figure 5-7. This permits access to the drum bearing

bolts.

3. Place a 5-millimeter Allen wrench through each hole and completely loosen

both bolts by turning them counterclockwise, until you feel them release from

the threads.

Service tip:

The bolts will not fall out even when completely loosened.

Figure 5-7: Drum Positioned with the Two Largest Holes Horizontal

4. Remove the six Allen-head bolts from the perimeter of the rear panel.

5. From inside the drum, push the drum upward and pull the rear panel outward

to remove.

Service tip:

If the panel does not release when the drum is lifted in step 5, ensure that

the two bolts in step 3 are completely loosened.

Note:

The drum rear panel will not fit through the front door. Reposition the

panel within the drum area as needed during servicing. Do not place

unnecessary weight or pressure on the panel.

T 15xx Dryers