Miele T 1526 기술 정보 - 페이지 38

{카테고리_이름} Miele T 1526에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1526 42 페이지. Vented dryer
Miele T 1526에 대해서도 마찬가지입니다: 운영 매뉴얼 (28 페이지), 운영 매뉴얼 (28 페이지)

페이지 인쇄

Technical Information

The "Anti-crease" LED is FLASHING - Fault stored. Proceed to "Access"

steps below.

Access (retrieval):

1. Access the service mode. See Section 6.1.2.

2. Turn the selector switch to "Woolens".

3. Press the Start button.

4. Note the illuminated LEDs.

5. Refer to Table 6-3 to determine the stored fault.

6. Switch the appliance off.

7. Perform the necessary service steps to rectify the cause of the fault, then

proceed to "Delete a Stored Fault Code" below.

LED(s) Lit Steadily

Rotary iron

Hand iron

Normal

Rotary iron & Hand iron

Normal and Rotary iron

Table 6-3: T 1576 Fault Codes

Delete a stored fault code:

1. Access the service mode. See Section 6.1.2.

2. Turn the selector switch to "Woolens".

3. Press the Start button.

4. Press and hold the Gentle button.

5. Press the Start button.

6. Release the Gentle button. The appropriate LED turns off.

7. Switch the appliance off.

6.3

Programming Mode (T 1576 Only)

Accessing:

1. Switch the appliance off.

2. Turn the program selector switch to 12 o'clock.

3. Press and hold the Gentle and Buzzer buttons.

4. Switch the appliance on.

5. Release the buttons.

Acknowledgement indicator:

The "Drying" and "Cooling down" LEDs flash to indicate that programming mode

is active.

Navigation:

1. Turn the program selector switch to the desired position; press Start to

activate the function.

2. The programmed option is indicated by the status of the "Rotary iron" LED.

Component

Fan NTC open circuit

NTC at heater bank open circuit

NTC at heater bank short circuit

Fan NTC short circuit

Maximum drying time (180 minutes) exceeded

T 15xx Dryers