Miele T 1576 기술 정보 - 페이지 35

{카테고리_이름} Miele T 1576에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1576 42 페이지. Vented dryer
Miele T 1576에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (40 페이지)

페이지 인쇄

T 15xx Dryers

5.11

Drum Drive Belt

1. Remove the lid. See Section 5.1.

2. Open the front panel; see Section 5.2 or 5.3.

3. Remove the rear panel of the drum. See Section 5.7.

4. Remove the heater bank cover; see Section 5.8, Step 2.

5. Lift upward on the drum so that a small gap exists between the edge of the

drum and the heater duct (refer to Figure 5-15).

Figure 5-15: Positioning the Drum to Form a Gap

6. Route the belt through the gap and onto the drum.

7. From the top of the appliance, ensure that the drum belt is positioned and

aligned correctly.

8. Access the rear of the fan motor through the space below the drum. Lift

upward on the fan motor tensioning pulley and place the drive belt onto the

pulley. The tensioning pulley should be holding the drum belt in position.

9. Ensure that the drum belt is aligned between the motor and the drum.

10. Hand-spin the drum slowly (this allows any minor alignment discrepancies to

be corrected).

Service tip:

Due to the limited space beneath the drum, access to the rear area of the

fan motor is via the space along the inner section of the right side panel

(above the fan motor housing).

Note:

Belt installation can be simplified by using the Miele "installation lever"

(part no. 05057330).

Technical Information