Miele T 1576 기술 정보 - 페이지 40

{카테고리_이름} Miele T 1576에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1576 42 페이지. Vented dryer
Miele T 1576에 대해서도 마찬가지입니다: 사용 설명서 (40 페이지), 사용 설명서 (40 페이지)

페이지 인쇄
Miele T 1576 기술 정보
Technical Information
8. Disconnect the wires to the drum and lifter bars at the pickup connection
plug.
9. Select “"20 mins. warm air”" in service mode and wait approximately 60
seconds.
a. “"Cooling down”" LED lights up: Check circuit outside of the control
electronic (slip rings, wiring, lifter bars, sensor contacts, etc.).
b. “"Cooling down”" and “"Drying”" LEDs flash alternately: Replace the control
electronic.
6.4.2

T 1576 Procedure:

1. Electrically connect one lifter bar and the drum body using clip leads or a wire
to simulate wet laundry and high conductivity.
2. Select “"Rotary iron”" in service mode. Press Start and wait approximately 30
seconds.
a. “"Cooling down”" LED lights up: Circuit is in proper working order.
b. “"Cooling down”" and “"Drying”" LEDs flash alternately: Resistance of
connection between controls and sensors is too high or is open-circuited.
3. Disconnect the wires to the drum and lifter bar at the pickup connection plug.
4. Jump the wires leading to the electronic (short-circuiting the moisture-
sensing circuit).
5. Select “"15 mins. cool air”" in service mode and wait approximately 30
seconds.
a. “"Cooling down”" LED lights up: Check circuit outside of the control
electronic (slip rings, wiring, lifter bars, sensor contacts, etc.).
b. “"Cooling down”" and “"Drying”" LEDs flash alternately: Replace the control
electronic.
6. Remove the wire jumper from inside the drum.
7. Select “"Fluff”" in service mode and wait approximately 60 seconds.
a. “"Cooling down”" LED lights up: Circuit is in proper working order.
b. “"Cooling down”" and “"Drying”" LEDs flash alternately: Circuit defective (lifter
bars, drum partially short-circuited). Resistance is < 50M .
8. Disconnect the wires to the drum and lifter bars at the pickup connection
plug.
9. Select “"Fluff”" in service mode and wait approximately 30 seconds.
a. “"Cooling down”" LED lights up: Check circuit outside of the control
electronic (slip rings, wiring, lifter bars, sensor contacts, etc.).
b. “"Cooling down”" and “"Drying”" LEDs flash alternately: Replace the control
electronic.
40
T 15xx Dryers