Miele T 699 C 사용 설명서 - 페이지 30
{카테고리_이름} Miele T 699 C에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 699 C 44 페이지. Novotronic super condenser tumble dryer
페이지 인쇄Problem solving guide
Check and indicator lights and display messages:
What to do if . . .
. . . the "Locked" indicator
light flashes when the ma-
chine is switched on.
. . . the "Locked" indicator
light comes on during drying.
. . . the "Anti-crease" indicator
light flashes.
. . . the "Empty out container"
light comes on.
. . . the "Clean out airways"
light comes on.
. . . once the programme has
started the following symbols
appear in the display:
"=== ... - == ...== ... - = ..."
. . . the programme is inter-
rupted, the "Anti-crease" indi-
cator light comes on and 0 ap-
pears in the display.
. . . the programme is inter-
rupted and "---" appears in
the display.
. . . shortly before the end of
the programme the count
down of the time left to run
halts at "10", but the dryer
continues to dry.
30
Cause . . .
The system lock is activated.
The programme cannot be
started.
That is not a fault.
Cold surrounding temperatures
below freezing are affecting the
machine (frozen condensed
water).
The condensed water container
is full.
The fluff filters or the condenser
unit are blocked.
The electronics are registering
that the machine is
underloaded.
This is not a fault.
If there is no laundry in the drum when the programme is started, the
electronics will register this and stop the programme. The
programme will also be interrupted if the laundry placed in the drum
is already dry.
See the section on "What to do if the drying process goes on too
long".
This is not a fault.
One of the pieces being dried is
considerably larger than items
that have been dried in
previous programmes. The time
left may vary from that
calculated by the machine for a
normal load.
Remedy . . .
See section "Electronic system
lock".
The light will go out at the end of
the programme.
Install the appliance in a
warmer room.
If the indicator light continues to
flash there is a technical
problem. Contact the Miele
Service Department.
Empty the container.
Check that the condensed
water container is correctly
positioned.
–
When the programme has
ended, clean the filters (see
section "Cleaning and care").
–
Clean the condenser unit
and check that it is correctly
positioned.
Always load the machine to full
capacity for economical drying.
See the "Display" section.
The drying process is not yet
complete. The programme
needs more time than the
electronic unit had calculated at
the start of the programme.
The time count down is
suspended until the degree of
drying selected has been
reached.