HP 314450-006 - Deskpro EN - SFF 6500 Model 6400 시작하기 - 페이지 7
{카테고리_이름} HP 314450-006 - Deskpro EN - SFF 6500 Model 6400에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 314450-006 - Deskpro EN - SFF 6500 Model 6400 29 페이지. Hp deskpro ap750: quick start
Method 2 (Manually Converting to NTFS)
1-4
Getting Started with Software
Before you manually convert to NTFS, you must have the
following:
A bootable MS-DOS diskette (OSR2 or later) having IDE
CD support or network support and containing the following
MS-DOS utilities: FDISK, FORMAT, and XCOPY.
Microsoft Windows NT Workstation 4.0 installation CDs
and the Service Pack 4 CD, or appropriate network share.
Appropriate Compaq device drivers, located at
www.compaq.com.
1. Insert the bootable MS-DOS diskette into the diskette drive
and turn on or restart the computer.
2. At the MS-DOS Prompt, run FDISK and press Enter.
3. When prompted, select large drive support.
4. From the FDISK main menu, select "Delete partition or
logical DOS drive" (Option 3) and press Enter.
5. Select the appropriate option(s) to delete existing partitions
or logical drives. The order in which FDISK will allow
deletion is as follows:
A) Logical drives lowest drive letter first (d: ... z:).
B) Extended partition(s)
C) Primary partition
D) Non-DOS partition(s) (at any time)
After completing steps 1-5, install the operating system as
described in the following section.